PX choke clips

[morelli]

Next dilemma folks is how do I re-fit the choke cable clips ?

I've been standing looking into the tank well for close to 2 hours now and I've had to admit defeat !!

Somebody please put me out of my misery !!!

How they hell do these clips go on ?

Thanks as always for your help .... And patience !

[sime66]

The ‘P’ shaped one goes in the slot in the tube nearest the frame, flat on top; it gives the friction to hold the lever in place.
The other one has a loop, which fits in the other slot in the tube – it stops the outer pulling into the tube; so the clip sits in the slot in the tube and clips over the cable, which passes into the tube just up to the spring clip-stop, which stops the outer.
Ignore the tape measure in this photo; it’s an image I did for the same question on Facebook a few years ago, but it serves the purpose here:



The Left hand image shows mine in place; I reckon that lot should sort you.

Funnily enough that image comes from a photo I posted on one of your threads when you asked about side panel levers; it just so happens that the same image shows the choke clips too – the whole image is here:

vespa.proboards.com/thread/4195/px-side-panel-levers

[morelli]

Thank you for that, I was using your photo from my previous side panel thread as reference but thick as I am I still couldn't figure it out !

No excuses now !! Thanks again