Torque Settings Needed

[vnb125]

Hello everyone

Following my son's encouragement, I have dug out an old, basket case of a VNB125 ((used to be blue) I have had since 1988. It's in a parlous state - covered in etch primer, bog and surface rust (unfinished project from around 2000)

We are assembling the front end and I have been greasing everything. 
I noticed the front axle was a bit grabby / resistant - as if too tight. 

I am trying to find a list of torque settings to ensure everything is correct before putting together. (paint can/may come later).

Also, are the lower steering head bearings loose (ie not packed in a race?)

Finally, is there a digital copy of a manual I can download? I have some pages from a Haynes manual and am missing sections.

Thanks for any help

Regards

Guy and Jude
Wollongong Australia

[ironsloth]

Hi, take a look at this:-

www.scooterhelp.com/serial/VNB.parts.book.html

This should help with missing diagrams, there’s full wiring diagrams on there too.

[soulboy74]

Front wheel hub nut 73nm-88nm rear hub nut 88nm-107nm the rest is up tight but Hay don't over do it had a look in the Haynes manual and not a lot about the front end l afraid sure someone will put you right on that one 👍 best foot forward soulboy74 🏴󠁧󠁢󠁥󠁮󠁧󠁿