|
|
Post by alan34 on Mar 8, 2022 19:02:17 GMT
Hello to everyone. Can anyone help with this question please. while I was cleaning engine i tried pulling clutch in to see if there was any movement on the flywheel the flywheel moved out about one mill not much but you could could see it.i rebuilt engine a couple of years ago with new bearings etc. only done around seven hundred miles since. it's a 2008 Px 125.lm wondering if it's a bit of a common thing thankyou for all your help cheers alan.
|
|
|
|
Post by adrian on Mar 8, 2022 21:22:51 GMT
After reading your post, I went and had a look at mine and girlfriend's px hers is a 125 and mine is a kitted 150 and there is no movement that I can see, 🤔
|
|
|
|
Post by alan34 on Mar 9, 2022 9:07:21 GMT
Hello there. thankyou for your reply adrian when you first pull clutch in you can see it move out a bit if you pull lever again it doesn't move so I turn engine over on kick start and try again and it moves out a bit have done not many miles since rebuild and ride gently I have a 2016 Px with 400 miles on clock which is on sorn no play at all on that one. If I have to strip it again I'll wait till late summer and get some use out of it cheers alan.
|
|
|
|
Post by alan34 on Mar 10, 2022 12:18:04 GMT
Hello there I've measured the move ment of the flywheel as it moves out a bit when pulling clutch in and its 0.40 of a mill after doing that I'm not panicking so much I know when I put bearings in there is a bit of movement in the bearing as the balls in the bearing have a bit of movement in them. so happy days and roll on summer cheers alan.
|
|
|
|
Post by adrian on Mar 10, 2022 19:25:13 GMT
👍 just keep an eye on it 👀
|
|
