|
Post by jonisingt35r on Sept 19, 2016 19:51:44 GMT
Hello
Rebuilt my px 200 e New piston crank and all bearings, got it installed trying to pluck up the currage and start it
Any tips on starting it for the first time, my only thoughts is to run it low revs slightly alternating speed for a while then take it out for a gradual slow speed trip
|
|
|
Post by doulsy on Sept 19, 2016 19:56:59 GMT
have you put gear oil in? i almost forgot when i rebuit mine, i have just done my 600 mile break in, its murder only time will tell if its done right.
|
|
|
Post by henri on Sept 20, 2016 6:17:15 GMT
yes ,1 tip , kick it ,kick it really hard? . actually , kick it over a few times with no plug ,get things moving ,a few times more with plug in but ignition off .then check ya chokes full on an go for a start ,rev as little as possible to stop it dying til tickovers adjusted an let it warm up on the stand . H
|
|
|
Post by vespasco on Sept 20, 2016 17:38:56 GMT
CHeck all the gears and clutch work before you start it too. Go easy on the throttle good luck
|
|
|
Post by jonisingt35r on Sept 20, 2016 23:04:30 GMT
Thanks I've already started to look for a spare one when this one goes bang
|
|