|
Post by baldmeister on Oct 8, 2013 19:55:12 GMT
hi , bought some disc pads for my px 125 but when i went to put them in they are smaller than the ones that came out! mines a 2011 when they started making again, anyone know if they made the caliper bigger? if i put the pads supplied in they rattle from side to side!! heeeeeeeeelp!!
|
|
|
Post by sbwnik on Oct 8, 2013 21:21:21 GMT
Pump the brake lever and they should lock into place properly
|
|
|
Post by baldmeister on Oct 9, 2013 15:56:31 GMT
hi, cool but will it be ok that the old pads are about 45mm measured across the width of the pads and the supplied ones are only about 35 mm??
|
|
|
Post by sbwnik on Oct 12, 2013 15:30:57 GMT
Depends.. What brand are they?
|
|
|
Post by baldmeister on Oct 13, 2013 15:59:52 GMT
hi, i have a set by mallossi and a set by ebc, bothe are too narrow.
|
|
|
Post by sbwnik on Oct 13, 2013 21:38:33 GMT
Don't know about the ebc ones, but I use the malossi ones on mine and never had braking problems. Ebc are a good brand though.
|
|
|
Post by baldmeister on Oct 20, 2013 14:58:51 GMT
hi, heres a pic of my pad (on right) compared to what is commonly recognised as a px disc pad. gets confusing!
|
|
|
Post by sbwnik on Oct 20, 2013 19:13:23 GMT
The ones on the left look wrong. I've just put EBC ones on mine, and they were full size.
|
|