|
|
Post by baldmeister on May 13, 2013 18:00:38 GMT
hi, anybody had any dealings with fitting a digital sip speedo ?
im fitting one to a 2011 px125 and was wondering where to attach the brown and red wires.
the sip instructions are poop!
also the rev counter seems to be registering a bit high.
any ideas ??
|
|
|
|
Post by kru251 on May 13, 2013 21:42:50 GMT
|
|
|
|
Post by pxguru on May 14, 2013 4:21:36 GMT
You will need a multimeter. to check you have the right wires. I cant remember the colours but they are easy to find.
Under the horn cast you will find the wires to connect to. The red wire goes on a 12V that switches on and of with the key without the engine running.
The brown wire goes on the wire that feeds the headlight switch. This only has power when the engine is running.
Under the horncast. Both wires are near to the bottom of the left hand side of the connector block, when looking from the front.
Check you have the rev counter setting right in the digital set up. There are quite a few options!
Still really pleased with mine. Works a treat.
|
|
