|
|
Post by bryno on Apr 19, 2007 18:55:49 GMT
Been out on a 100 mile round trip today, fair bit through town, I've had a problem with what I take to be fuel evaporation, after ticking over at lights or whatever, the engine nearly dies as I go to pull away, near cut out a few times, soon as I give it some revs it's back to normal and no problems on the move.. It's been hot today, but not exactly cracking flags, does anyone else experience this problem? didn't have it through last summer  |
|
Lan
High Number
Posts: 152
|
Post by Lan on Apr 20, 2007 18:46:07 GMT
what like where it bogs down and almost stalls but u giv it some boot and it goes again??
|
|
|
|
Post by Spence on Apr 20, 2007 19:11:31 GMT
Is it dying as the engine ticks over, or when you actually start to apply revs?
|
|
|
|
Post by bryno on Apr 21, 2007 10:47:53 GMT
Ticks over fine, it then bogs down when I apply throttle, I can get it to stall if I open the throttle too fast.. if I give it a second to pick up, it's fine again. It's doing it again today Any ideas? I'm sure it's fuel related, and only happens if I tick over for a min or so, when on the move it's fine.. |
|
|
|
Post by Ilan on Apr 21, 2007 11:20:41 GMT
sounds like you should tune the carb mixture
|
|
|
|
Post by Spence on Apr 21, 2007 11:31:24 GMT
Yes it sounds like the engine's flooding when you open the throttle.
|
|
|
|
Post by bryno on Apr 21, 2007 19:39:54 GMT
Could be.. I did set the mixture the other week, following the manual, just found the point where it ticks over fastest and most even.. any other thoughts on how to set it up?
|
|
|
|
Post by Ilan on Apr 22, 2007 15:41:08 GMT
could be a little raise in the rpm at idle might solve this
maybe the carb is set too low right now..
|
|
|
|
Post by uniteddazza66 on Apr 23, 2007 14:41:31 GMT
Hi, I had the same prob on my scoot, 2 probs in one 4 me tho. 1st was the flywheel oil seal leaking (can be checked by inserting your finger inside cover) 2nd was a carb jet blocked with a bit of sh*te Replaced seal and cleaned out jets n it now runs sweet. Hope this helps, Daz
|
|
|
|
Post by bryno on Apr 23, 2007 19:56:42 GMT
Cheers guys, I stripped the carb down again, gave it a good clean out and it seems to be better now, though we're only seeing 20 degrees down here at the mo ;D Not got any oil leaks thankfully and mixture seems to be ok, it ticks over real smooth, well as smooth as a T5 ever will be  |
|
