shyman
2nd Class Ticket
Posts: 23
|
Post by shyman on Dec 2, 2019 11:35:03 GMT
Hi all, my Mrs kindly bought me a new chrome hub for the front wheel on my PX. i'm getting a new set of bearings & seals etc but was wondering if i need a press to put the bearing in or just use a socket/old bearing & a big hammer. any other tips for fitting the bearing very much appreciated.
|
|
|
Post by ironsloth on Dec 2, 2019 19:02:27 GMT
Use a press if you can, but if you t**t it with a hammer, make sure it goes in straight.
|
|
|
Post by mijapxman on Dec 3, 2019 19:18:37 GMT
If you are going to "tap 😉" them in, tap on the side of the bearing that has letter or numbers on it. Heat the hub and freeze the bearing is a better way. If they are tight you could pull the in using a suitable threaded bolt and washer, like a clutch compressor.
See here, approx 13 minutes in...
Mij ☺
|
|
shyman
2nd Class Ticket
Posts: 23
|
Post by shyman on Dec 4, 2019 7:51:05 GMT
Brilliant, thanks for the advice.
|
|