|
|
Post by phattanglo on Jul 21, 2019 7:42:09 GMT
Could anyone advise please if it is realistic to drill out the spot welds on a std disc front mudguard to split it and then re-weld after rust removal. My mudguard has the usual rust down the front seam and I used a fibreglass replacement, but despite much jiggery pokery it just doesn't fit as neatly as I'd like and I wondered if I should revert back to original. |
|
|
|
Post by ianmartin40 on Jul 21, 2019 10:06:32 GMT
I have never heard of anyone doing what you are suggesting, A lot of people change to a T5 mudguard to eliminate the seam altogether, mudguards are not expensive to buy a new one but the cheap ones may not fit that well, possibly worth trying to source a decent second hand genuine one, unless you like a challenge.
Ian
|
|
|
|
Post by toystory on Jul 21, 2019 15:02:15 GMT
I put a T5 on mine, looks nice. Good second hand ones about. I don't mind welding but I would probably blow holes in that : )
|
|
