|
Post by jellerby on Sept 14, 2017 11:28:20 GMT
About to put the gear selector back on the P, any tips on putting it back on? I had a quick go with it yesterday with no luck. The gear cables aren't attached as of yet though, that wouldn't be a problem though would it? The selector is in neutral position and so is the handle.
cheers
|
|
|
Post by henri on Sept 14, 2017 12:50:52 GMT
move selector to 4th position an then a bit further ,grease n put on a new gasket .hook selector arm onto rod an line up studs an a bang with the palm of ya hand an it should be on an back in nuetral. flat washer then spring then nuts done to 14 lb/f an jobs done . H
|
|
|
Post by jellerby on Sept 14, 2017 17:19:17 GMT
So 'batwing' just past 4th position, what about the rod? Any position for that? I guess the cables can be done afterwards?
|
|
|
Post by henri on Sept 15, 2017 6:10:28 GMT
in neutral for the rod , H
|
|
|
Post by scooterg on Sept 15, 2017 22:21:29 GMT
Rear wheel off the ground,,,is a MUST MUST MUST First time I done this I broke two,as the wheel wasn't off the ground
|
|
|
Post by jellerby on Sept 15, 2017 22:34:26 GMT
Managed to get the selector on tonight, torqued the nuts up to 11nm and stripped the thread on one of the studs... Back to square one again
|
|