PX 150 mixture adjustment spanner

[Hobbyhorse]

The PX was a bit hesitant at low revs, particularly when changing gear which, to me, indicated a tweak needed on the mixture screw. The 7mm nut in behind the starter motor is a bit of a devil to get at so: used a piece of 20mm x 3mm aluminium  strap in which I cut a 7mm slot in the end and bent that at right angles and I now have an offset spanner. The mixture adjustment did the job and the scoot is going well.

I am sure this is not the first time it has been done that way, the main thing is that it worked.

[gillie]

any pics??

[Hobbyhorse]

Gillie, I have not been able to load a picture for some reason. It is basically a piece of 25mm x 3mm aluminium about 300mm long with a 30mm section turned at right angles at the end and a 7mm slot cut in the upstanding piece.