djbmc
2nd Class Ticket
Posts: 15 
|
Post by djbmc on Jun 20, 2016 18:56:57 GMT
evening all
can anyone advise how to get the switch/ brake lever housing off my VBB handlebars ? can't work out how it's done so far .... I'm told there is a "splitpin" type thing in the headset but have no idea what one of these this looks like
cheers
|
|
|
|
Post by henri on Jun 21, 2016 10:17:06 GMT
if you mean the aluminium bit brake lever bolts into ,its heat an a hammer to knock it off ,an heat an soft hammer to put new one back on,being careful the hole for brake cable lines up.
if its the throttle tube the handlebar grips on , you need to remove the brake cable as it runs through it ,an inside the headset theres a throttle wheel the throttle cable attaches to.this is held on by a R clip not a split pin an needs to be unclipped . H
|
|
djbmc
2nd Class Ticket
Posts: 15
|
Post by djbmc on Jun 22, 2016 9:26:02 GMT
cheers Henri
I'm intending to re-use the handlebar so it'll be the hammer job which I'm going to leave to my local repair shop as I've neither a heat gun or the urge to start belting my scoot with a hammer ...
|
|
