|
|
Post by phattanglo on Mar 8, 2015 14:23:12 GMT
After replacing a cat exhaust with a std one, I found myself needing to fit a new centre stand spring.
Beedspeed sent me the old style spring as it's the cat exhaust that necessitates two thinner springs.
Do I need to take the exhaust back off to fit the spring or is there a knack.
|
|
|
|
Post by henri on Mar 8, 2015 17:12:41 GMT
i use a spring hook ,makes the job easy , you can tie a loop of shoelace thru spring an stick a screwdriver/extension bar through to pull on ,get one end in an pull/extend spring til ya can match up other end with the stand , H
|
|
|
|
Post by ianmartin40 on Mar 8, 2015 19:16:36 GMT
Anyone with a kids trampoline will have a good strong spring puller as they come with one
|
|
|
|
Post by kru251 on Mar 10, 2015 10:23:01 GMT
I used locking wire clamped into a loop with good Vice Grips (Mole Grips).
BUT, word of warning. DO wear eye protection as these spring things have a lot of power and having seen a spring end break due to poor heat treatment with a flying bit of tempered steel about 8mm long & that isn't funny!!!!
|
|
