|
|
Post by fredperrybruce on Jan 9, 2013 19:58:09 GMT
Hi, can anyone tell me what's the best way to touch up paint work on my front PX mud guard please. I had an accident few weeks ago and scratched the front mud guard, nothing too serious about 1 inch square on the front corner. I heard some wet&dry paper ,primmer filler, spray paint will do but as iv'e never done this before I need some tips. Thanks ;D
|
|
|
|
Post by sbwnik on Jan 9, 2013 21:27:44 GMT
Rub it up smoothly, and make sure it's level. Use a filler primer to key it properly. Even, smooth strokes with the spray. Allow to dry to almost perfectly dry, but not too much. This is a hard one to explain. If any runs, let them harden, then sand back and respray.
Patience is always the answer. Finally blow over with a couple of coats of lacquer.
Most importantly though, make sure you're spraying in a warm and dry environment, otherwise you'll get it blooming.
|
|
|
|
Post by kru251 on Jan 9, 2013 22:29:09 GMT
Lots of "How to" on You Tube as car stuff translates to scooters, as in same only smaller areas!!!
|
|
