Floorboard runner kit

[stevomtb1]

Hi, Just purchased a floorboard runner kit for my PK and I am a bit confused.
In the pack there are these 12 pin thingies(no thread, hole) with a domed top. I assume these are used to fit the rails to the frame but how?
There were rivets in the pack also and I can see that these will be useful.
The scoot never had runners before so there are no holes for me to follow/old ones for me to see how they fit, so any help will be more than useful.

[scooterwarehouse]

Have the Black Pastic end caps got holes that go right through or just one end?If your floor has no holes for runners you probably have the XL model which had rubber mats instead of runners.To determine your model does it have a Petrol Gauge on the Speedo or is it a small round Speedo ?If you can answer these questions i will give you a few ideas

[stevomtb1]

It is a PK50 XL.
The plastic end caps have holes half way through them(not all the way through.

It did originally have rubber mats but they look poo as they have faded to a greeny grey.

Not happy anyway as there are no bridge piece runners for a PK according to Beedspeed.

[scooterwarehouse]

Okay you will have to mark your floor alloy channels into position and drill through the holes in the channels.you only want to use about a 3mm drill.You will then need a pop rivet gun to attach the channels leaving the two ends of each channel not riveted. the rivets with the dome heads are useless. you will need to get some rivets about 8mm in length to fit the endcaps.When you use the gun they will squeeze into the endcaps and tighten.I forgot to say before you fit the encaps fit each channel rubber into position.I hope this helps

[stevomtb1]

Nice 1.

Any idea what I can use for the bridge piece?

[scooterwarehouse]

Yeh you can use a Black dimpled mat that is fitted to the Primavera and the ET3.This will line up and fit your PK perfectly