|
|
Post by beemerman on Jun 6, 2011 20:56:14 GMT
daft wuestion but i have a haynes manual for my px125 disc is there an easy way to adjust rear cable as when i press break pedal it doesnt come all the way back so break light stays on is it just a case of adjustment i know there is an adjuster to take up slack cable but think its adjusted fully should i get wheel of and chesck drum pads and how easy to do is it oh and im going to tackle decoking the head what is best way to do it ie wire wool or is that to abrasive
|
|
|
|
Post by mark on Jun 6, 2011 21:10:52 GMT
Give the brake pedal a good squrt of wd40 underneath they quite often stick and dont fully return
|
|
|
|
Post by beemerman on Jun 7, 2011 9:11:38 GMT
ok i shall give it a go
|
|
|
|
Post by jackthekipper on Jun 7, 2011 17:15:25 GMT
yeah, it used a full can of WD to free mine...just keep squirting it in while yer pressing the pedal with yer left hand. ..fine wire wool might be ok for the head..but i find rubbing it with T CUT the best
|
|
|
|
Post by beemerman on Jun 8, 2011 14:06:22 GMT
after loads of wd40 it has freed it loads its still not 100% so more wd tonight
|
|
|
|
Post by jackthekipper on Jun 8, 2011 17:20:26 GMT
forgot to say it would better to loosen the three nuts underneath so the pedal drops down....you can then see the light button to WD
|
|
|
|
Post by beemerman on Jun 10, 2011 8:59:19 GMT
cheers for your advice undid bolts sprayed wd40 loads and loads pedal now springs bad like a new one superb !!
|
|
