|
Post by Devo McDuff on Aug 18, 2008 15:27:48 GMT
What would you say a reasonable price is to supply and fit this setup?
Been quoted £390 by one scoot shop.
|
|
|
Post by Smallframe on Aug 18, 2008 20:27:51 GMT
Is that including matching the transfers, cutting crank web and opening inlet ie: complete engine strip. If its just a plug n play job then I think its OTT . Its about £180 for the kit n pipe
|
|
|
Post by Devo McDuff on Aug 19, 2008 4:42:35 GMT
Plug 'n play.
Another shop quoted about £330, though they are gonna be shutting down for a few months anyway.
|
|
|
Post by joey on Aug 19, 2008 16:56:38 GMT
That's a pi*s take, it should take no more than an hour to fit kit, pipe and rejet, I'm a plumber and don't charge £150 for an hours work! Pity you can't get the scoot down to Chester mate, I'd fit it for the price of a few beers!
|
|
|
Post by Smallframe on Aug 19, 2008 19:24:34 GMT
Toughest part of the job is removing the piston nearside circlip and thats about as fiddly as it gets mate . Its easy , get a mate to do it .
Just get your timing set right !
PS, I have a strobe light
|
|
|
Post by elviswasamod on Aug 19, 2008 19:34:20 GMT
devo if your going to spend that sort of money you may aswell get a p2 engine seconhand of ebay if your lucky .cus at the end of the day it will always be a px 125 if as mick said its not matching the transfers etc total waste of money
will give you a bell saturday afternoon in ryde for a few scoops
|
|
|
Post by Devo McDuff on Aug 19, 2008 20:06:26 GMT
Hmm, food for thought as ever on this board ;D
Just PM'd you Joey!
PS Good stuff Ferdy, se ya then.
|
|
|
Post by dave1967 on Aug 19, 2008 21:32:03 GMT
For £350.00 take it to a merc dealer they only charge £100 per hour and at the most its a two hour job. Being really honest you could do it yourself and even if you have never done it before its 3 hours tops. If your really stuck bring the bits down to the IOW rally drop round for a beer and I'll do it for you for £50.00.
|
|