|
Post by jackthekipper on Jun 8, 2017 10:58:42 GMT
oreet y'all...bit of advice needed please...changed my carb (exactley same make as the one i removed s24 24)same jetting,everything...the only thing i'm concerned about is the air screw setting..instead of being wound out 3 turns,it only winds out 1 to get the correct tickover..mixture scew 1 1/2 turns same as before...is this normal with another carb ?..the one i removed says del'orto spaco ,the new one just says spaco...P.S tis a PX 200 with 210 mallosi kit fitted..cheers for any advice .... another PS...the slide on the new carb is closed a bit more than the old one when slack
|
|
|
Post by henri on Jun 8, 2017 16:55:27 GMT
all-reet jack , how ya diddling . did old carb have a hex head mix screw an new one a screw head .as difference between hex/fine thread an screw/coarse thread would account nicely for the difference . but if new ones runnin fine an showin good plug colour could just be down to manufacturing tolerances ,or old one being worn an leakin air past slide needing a richer mix setting . H
|
|
|
Post by jackthekipper on Jun 9, 2017 6:25:33 GMT
cheers henri...think ya got it with the mix screws pal...gonna give it a good run today to check Mr sparking plug...
|
|
|
Post by djloone on Jun 9, 2017 15:59:15 GMT
no expert but def with Henri..can remember posts about the differences ....+ if it works..then funk it all good )
LOON-E
|
|