|
|
Post by jellerby on Mar 15, 2017 21:56:59 GMT
How do I go about changing the PM Tuning lever back the standard front brake lever on a Smallframe? Also while I'm doing the front brake how do I adjust it so I have more to brake with?
|
|
|
|
Post by henri on Mar 16, 2017 6:47:01 GMT
drum cable brake = release cable at lower end ,undo pivot screw ,a 8mm nylock on underneath locknut 1st then pivot unscrews. remove pivot an slide out the lever,carefully catching the wavy washers that space the lever .unhook cable from lever ,an reverse the process with new lever .then push brake arm forward on backplate til brakes are almost on,pull cable tight an tighten clamp nut .try brake a few times an then adjust out any slack thats appeared.
disc brake=undo pivot bolt an remove lever an bolt in new one ,simples.H
|
|
