|
Post by hully1 on Sept 8, 2015 8:48:06 GMT
hi Chaps,
fitting a new 24/24 carb to my PX which is running a DR180 with Sito plus exhaust and 22 tooth clutch any suggestions on what jetting is best for the new carb. currently standard 20/20 fitted.
cheers
Hully
|
|
|
Post by bignico2411 on Sept 8, 2015 13:24:17 GMT
Hully, trawl back through some of recent threads on here, pretty sure jetting of kitted scoots has been discussed recently
|
|
|
Post by henri on Sept 12, 2015 13:02:23 GMT
not bad prices there gaz ,might have to have a shopping binge soon , theres also "German Scooter Forum" large frame tech section ,theve a bit where guys list there specs/kits/work done an carbs n jetting ,what jets did you have in the 20/20 before . as gaz says p200 is a good start point ,be3 atomiser an 116 main, but reckon you'll end up 112/114 , rab had a 24/24 on his mallosi kit if memorys serving . an switched between that n a 20/20 , his jettings will give you a guide to the differences .message him n ask . H
|
|
|
Post by sime66 on Sept 14, 2015 6:17:26 GMT
Before I changed to a SIP Road 2, I had DR180, Sito+, and a 24/24, non-autolube, with a drilled filter and 118 mj. (160, BE3, 55.160):
|
|