getting seal off

maxifields High Number Posts: 164	getting seal off Jun 2, 2015 18:10:45 GMT Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by maxifields on Jun 2, 2015 18:10:45 GMT I can't seem to get this seal off front bearings of my sprint .Is there a knack trying not to break it ,any help is much appreciated. www.scooterhelp.com/tips/engine/_bearings/old.vespa.wheel.bearing04.jpg
	Last Edit: Jun 2, 2015 18:16:51 GMT by maxifields

henri
Ace Face

its not about pulling up in a perfect 3 point turn an stepping into ya grave sayin "is that it" .H

Posts: 4,712

getting seal off Jun 3, 2015 7:42:41 GMT

Quote

Post by henri on Jun 3, 2015 7:42:41 GMT

thats a output shaft/hub seal in piccy , the seal retainer is a left hand thread , an its usual to lever them out destroying in process an replace em , make a note of size first as theres 2 sizes of hub/seal that both can fit on the same splines/shaft , 27mm an 30mm ,if memorys right , H

if its got wheels n makes a noise I wanna play with it, skateboards included coz "skate-punks rule",

maxifields High Number Posts: 164	getting seal off Jun 3, 2015 17:04:49 GMT Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by maxifields on Jun 3, 2015 17:04:49 GMT all sorted just being over cautious, thanks Henri

Post by maxifields on Jun 2, 2015 18:10:45 GMT

Post by henri on Jun 3, 2015 7:42:41 GMT

Post by maxifields on Jun 3, 2015 17:04:49 GMT