|
Post by bigd on Mar 5, 2015 16:48:48 GMT
|
|
|
Post by henri on Mar 5, 2015 17:04:29 GMT
just been reviewed in scootering an they rate it , i'm tight n will stick with a cable tie n swapping little trunnion bolt for a 6mm allen headed grub screw ,makes it almost easy ,if ya a double jointed ambidextrous dwarf that is ,H
|
|
|
Post by sime66 on Mar 6, 2015 4:23:26 GMT
I use a bit of old thin bungee. It's something I've always carried for tweaking my derailleurs on cycles, It's part of my on-board tools, and it works well for adjusting clutch and brake cables on scooters too. Loop it round the clutch arm and the stand, take up the slack, and it's sorted.
|
|
|
Post by rab on Mar 6, 2015 19:26:46 GMT
i try get someone else to do it its loads easier drinking a pot of tea and watching it being done
|
|
|
Post by henri on Mar 7, 2015 11:56:40 GMT
not me you wont , i'd scratch ya paint to get even , H
|
|
|
Post by kru251 on Mar 7, 2015 12:15:56 GMT
I too use a cable tie; a re-useable one. Set it up etc. Do the job; push the cable tie's plastic tag back, it unlocks; job done. Cost was about 50p I think, but that is a nice shiny tool so if it does a good job and yer happy; well it's a result.
|
|